PASO 7
MK3S+ Trimmed electronics door installation
Re-attach the door back onto the bottom hinge.
Make sure the top hinge is in place.
Attach the top hinge to the printers frame using the M3x10 screw.
Make sure there is enough clearance for the MMU3 cable when you close the door.
The cable should be held by the door but must not be squished too much.
Otherwise, you risk damaging the cable!
PASO 8
MK3S+ Electronics wiring diagram
In the following step, we will connect the cables to the already existing connections
on your Original Prusa MK3S+. Please, proceed very carefully.
Follow the diagram shown here in case you need to reconnect any of the extruder
cables into the Einsy Rambo control board.
Since, MK2.5S printer isn't officially supported in combination with the MMU3, this
guide doesn't cover connecting the electronics on it. Instead, it is described in the
MK2.5S MMU2S guide.
162
10B. Configuración y Calibración MK3S+
Ensamblaje Original Prusa MMU3
