PASO 28
Extruder-idler-mmu parts preparation
Para los siguientes pasos, por favor prepara:
Extruder-idler-mmu (1x)
Make sure you're using the correct new part.
Engranaje Bondtech (1x) que has retirado previamente del tensor original.
Needle Bearing (2x) you have removed from the original idler before. Might still be
inside the gear.
M3n nut (1x)
Shaft (1x) you have removed from the original idler before.
PrusaLube (1x) the supplied lubricant
PASO 29
Bearing assembly & Greasing
Add a tiny bit of lubricant into the needles in both of the bearings. Wipe off the
excess grease to prevent spreading it all over the place.
Insert both bearings into the Bondtech gear. Make sure the bearings do not slip out
during the assembly.
Add a tiny bit of lubricant into the geared part of the Bondtech gear.
Make sure the lubricant doesn't get into the filament groove.
Do not use excessive amount of lubricant. Just a tiny bit will do.
120
9B. Mod extrusor MK3S+ / MK3.5 (KIT)
Ensamblaje Original Prusa MMU3
