PASO 38
Attaching the hotend cables
Push two zip-ties through the upper slots on the cable-holder. Tighten the zip-ties
up slightly around the hotend cables.
Arrange the cables from the hotend into the dedicated channel on the bottom.
Tighten up the zip-ties and cut the remaining parts of the zip-ties.
PASO 39
Continue
If you're installing the MMU3 on an MK3S+ printer, move to the chapter:
MK3S+ Setup and Calibration
If you're installing the MMU3 on an MK3.5 printer, move to the chapter:
MK3.5 Setup and Calibration
9B. Mod extrusor MK3S+ / MK3.5 (KIT)
Ensamblaje Original Prusa MMU3
125
