PASO 3
xBuddy preparation
On the left side of the printer, remove the four M3x6 screws holding the xBuddy
box cover in place. Then, take off the cover.
Loosen the two M3x18 screws holding the ext-cable-holder.
Raise the cable holder.
Use needle-nose pliers to remove the indicated part of the cable holder, creating
space for the MMU cable.
PASO 4
Guiding the cable
Guide the cable from the MMU unit along the frame, directing it towards the
electronics.
Guide the cable into the xBuddy box through the opening on top.
Connect the MMU cable into the marked connector on the xBuddy board.
10A. Configuración y Calibración MK4
Ensamblaje Original Prusa MMU3
143
