Envirologic EVO Cleaner Manual De Usuario página 16

Ocultar thumbs Ver también para EVO Cleaner:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 86
English
Automatic wash
Before cleaning, check the following:
1�
That no magnetic position marker brackets have been moved or are
missing
2�
That each magnetic position marker is fixed in the correct bracket
3�
That the magnetic switch arm is set 5 cm from the middle of the magnetic
markers�
4�
That the area to be cleaned is clear of obstacles, which can interrupt the
cleaning process
5�
That the high pressure cleaning unit is powered up
6�
That water is connected to the high pressure cleaner
7�
That the high pressure hose is free to move and secured centrally behind
the hose reel
8�
That the charger is disconnected
9�
That the guidance wheels are placed in the correct position, see screen.
10� That you know where to start the cleaning process, check for the first
position marker
11� That the area to be cleaned is cleared of humans and animals
To start running a working scheme (automatic wash) select START on the start
screen. First select which location to run. Then select which recipes to use in the
order they should be run. Before starting the wash, make sure to put the robot
within 1 meter before the first position marker. Make sure the guidance wheels are
in contact with the wall on the side of the aisle where the markers are located�
After the first marker has been found the robot will automatically execute the
listed recipes and programs� Between each recipe the robot will move back to the
first marker.
Aborting
An automatic wash can be aborted before it is finished in two ways:
When pressing stop the robot will finish the current program before stopping
When pressing pause or the Emergency stop switch, the program will be
immediately stopped if the stop button is pressed.
If the emergency stop switch has been pressed the wash will immediately continue
if the stop switch is restored and the alarm is cleared on the screen�
8� Teaching hints
1� The teaching process should take place using working pressure, because the arm
is affected by the power from the flowing water.
16
loading