EN
The robot cleans with high-pressure water (warm or cold) with or without
additives. The water is supplied from an external high-pressure water supply via a
50 m hose installed on a hose reel that is operated separately by the robot
according to how the robot moves� The cleaning is carried out by a telescopic arm,
moveable in all directions, with a maximum reach of 4015 mm (effective working
range including the water jet is 6 m). By using the joystick, you can teach the robot
to move and clean in a satisfactory way. After this teaching operation the robot will
be able to carry out the movements on its own as many times as are necessary to
achieve a satisfactory cleaning result.
Starting the robot
The main switch is found on the right-hand side of the operator panel� When the
robot is switched on, the startup process takes about 30 seconds� When the screen
in Figure 4 is shown the robot is ready to operate�
Figure 4, start screen
Help system
Every screen has a button with a question mark, as seen in Figure 4. When pressing
that button, relevant help texts will be displayed on the screen.
Charging the robot
When charging the batteries, the cleaning robot must be switched off. The
batteries cannot be charged when the robot is on. The charger must be connected
to the robot before it is connected to the wall outlet� When the charger is
connected to the wall outlet only the orange status light should be turned on� See
the charger manual for details� The cleaning robot shall always be connected to the
charger when not used, in order to prolong battery life.
11