Making The Device Ready For Use; Unpacking The Device - Weinmann MEDUCORE Easy Descripción Del Aparato E Instrucciones

5. Making the device ready for use

Unpacking the device

Carefully remove all components from the packaging.
Check the components for completeness using the "Over-
view" on page 4. Check all components for damage. If
components should be missing or damaged, contact your
dealer or the manufacturer Weinmann direct.
Warning!
Packaging material represents a suffocation hazard.
Keep it out of the reach of children or dispose of it
properly.
Note
We recommend connecting the device to a PC on
which the EasyView software is installed in order to
check the settings of the device and adapt them if
necessary (see section 6.4 "Administering use/device
data using EasyView" on page 33 and the EasyView
instruction manual).
Check device
1. Open the lid of the device as shown in the adjacent
drawing.
2. Check whether the electrode plug is plugged into the
socket intended for it on the user interface. The plug
is designed to be impossible to connect incorrectly, so
it can only be plugged in as shown. Push the plug
firmly into the socket if necessary.
3. Check whether the electrodes are lying on the user
interface of the device with the symbol uppermost.
Position the electrodes in this way if required.
4. Check whether the emergency kit supplied (consisting
of: razor, scissors, mouth-to-mouth resuscitation
shield) is attached behind the clip in the lid of the
device. Position the emergency kit in this way if
necessary.
Making the device ready for use
EN
19