Pressure Transmitter - Pontos AquaCycle 2500 Instrucciones De Montaje

7.6. Pressure transmitter

The pressure transmitter measures the
hydrostatic pressure in all three tanks and
sends information about their fill levels to the
controller.
Checking the pressure transmitter
Compare the fill level value on the display
(L01, L02, L03) of the controller with the actual
fill level.
Replacing the pressure transmitter
To remove the pressure
transmitter, drain all water
out of the relevant tank.
For the safety instructions, see the start of
chapter 7
1. Allow the relevant tank to drain completely
empty via the ball valves.
2. Unplug the system's main plug.
3. Detach the power plug connection.
4. Unscrew the pressure transmitter anti-
clockwise out of the tank.
5. Replace the pressure transmitter and clean
the through-hole.
6. Install the new pressure transmitter in
reverse order. When doing so, make sure
that the flat seal is correctly installed.
7. Check for leaks and function (see chapter
6.8.2).
Version 2.5
Operating Manual AquaCycle 2500
EN 51