Product Identification - Pontos AquaCycle 2500 Instrucciones De Montaje

Warning!
Contact with dirty water
can be a health hazard.
Wear suitable
protective gloves
when carrying out
work that brings you
into contact with the
waste water.
Danger!
Potentially lethal mains
voltage.
Carry out all work on
the system only with
the electrical power
switched off. De-
energise the system
before opening the
controller – unplug
the mains plug!
Make sure that the
supply voltage
cannot be switched
back on again
accidentally.
Electrical connection
Electrical systems must conform to the general
set-up regulations IEC 364/VDE 0100. Sockets
must have earth terminals.
The electrical mains (230 V~/50 HZ alternating
voltage) to which the water recycling system is connected must have a 30 mA fault current
protector (residual current circuit breaker) as
demanded by DIN EN 60335-2-41/VDE 0700.
Consult a specialist electrician if necessary.
Version 2.5
Operating Manual AquaCycle 2500
If the electrical connecting cable is damaged,
replace it with a H05RN-F3G 1.5mm² cable
with a protective contact plug IP44 (with
protective splash collar) as specified in DIN VDE 0620 (2010).
Note!
In the event of a power
failure, the water recycling
system is not ready for
operation and downstream
applications cannot be
supplied.
Caution!
UV radiation can cause skin
and eye damage
Work on the UV lamp may
only be carried out by a
specialist.

2.3. Product identification

The rating plate is on the right next to the
controller.
The following are shown on the rating plate:
- Manufacturer's name and address
- Product name / type
- Protection type (DIN EN 60529, DIN 40050
part 9)
- Protection class (DIN EN 61140)
- Connected voltage / frequency
- Max. total power / max. power consumption
- Document number of the Operating Manual
- CE mark
- Series number of the product
-
TÜV inspection sticker
EN 11