Instructions For The Operator - Pontos AquaCycle 2500 Instrucciones De Montaje

3. Instructions for the
operator
In addition to the safety instructions, please
observe the following basic directions:
Permanently identify all process water
•
tapping points with the notice "Not drinking
water". This also applies to garden taps.
If you use removable or lockable turning
•
handles on publicly accessible outlet valve,
these must not be replaced by a top with a
toggle handle. After using the valve,
remove or lock the turning handle.
Inspect the system if changes in water
•
odour, colour and / or suspended materials
occur at the taps. If necessary, consult an
expert.
Do not use any chemicals or additives to
•
operate and clean the system.
There must be no connection between the
•
drinking water and the process water.
Shut off and drain the taps and process
•
water pipes that are not frost-protected in
good time before the onset of winter.
If there is a risk of frost during extended
•
shutdowns or when in storage outdoors,
make sure that the system is completely
empty and that there is no water in the
pumps and pipelines.
Avoid static loads (e.g. by hanging objects)
•
on all infeed, overflow, drainage and
tapping pipes.
The information on possible water savings
•
are approximate values, and are
dependent on system operation.
The quality of the fed-in rainwater must be
•
in line with the quality as stated in the fbr
Information Sheet H201. Otherwise,
Pontos cannot accept any responsibility for
the quality of the process water.
Use only the process water from Tank 3 for
•
the filter backflush and the cleaning hose
connected to the pipeline. Never use
drinking water.
EN 12
Operating Manual AquaCycle 2500
Version 2.5