a
a. Specified position : 0~1mm
a. Position spésifiée : 0 à 1mm
a. Posición especificada : 0~1mm
q
1. Locknut (×2)
1. Contre-écrou (×2)
1. Tuerca de bloqueo (×2)
w
2. Adjuster (×2)
2. Dispositif de réglage (×2)
2. Tensor (×2)
7. Tighten the joint screws of each carbure-
tor.
Throttle cable adjustment
After the jet needle clip positions are changed,
throttle cable adjustment may be necessary.
1. Move the throttle lever a few times.
2. Push the throttle lever forward until it stops
and hold it in this position.
3. Check through the window of each carbu-
retor to see if the punch mark on the throt-
tle valve is at the specified position.
4. If not, loosen the locknuts and turn the
adjusters until proper position is obtained.
5. Move the throttle lever a few times and
recheck the position.
6. Install the fuel tank, side cover, radiator
cover and air filter case cover.
7. Reconnect the fuel hoses.
8. Install the seat.
8-65
