Conversion - ORMED.DJO ARTROMOT-E2 Manual De Operación

6.4 Conversion

Note!
On the display the respective sides are
indicated as follows:
- The CPM device (upper arm sup-
port) is prepared for the left elbow.
- The CPM device (upper arm sup-
port) is prepared for the right elbow.
- This symbol appears during con-
version of the CPM device.
6.4.1 Reconfiguration of the
ARTROMOT®-E2
The ARTROMOT®-E2 can be used on the left
and on the right elbow joint. However, the
device must be converted first. This is done
very quickly.
1. Activate the "transport setting" func-
tion in the menu (see also 5.3)
and start the ARTROMOT®-E2.
2. Adjust an angle of 90° for horizontal
adduction/abduction (indexing knob 1)
(see conversion drawing
3. Open locking screw (4) for the height
adjustment, remove the armrest for
the healthy arm and place it on the
seat (see conversion diagram
Conversion diagram ARTROMOT®-E2:
1
4. Hold the double joint (3) of the motion
5. Remove the motion element and insert
6. Pull the pin for the swiveling move-
7. Open the locking screw for the swivel-
8. Open the locking screw for right/left
).
1
).
1
2
81
element and open the locking screw
for height adjustment (4) on this side
as well.
it on the opposite side. Tighten the
locking screw (4).
(see conversion diagram
ment of the upper arm support (11)
downward and swing the support 180°
towards the inside.
Attention: Release the pin (11) while
the support is swinging; you will hear
it lock into place on the other side (see
conversion diagram d)
2
ing movement of the forearm support
(12) and swing the support with motor
B 180°. Tighten locking screw (12) (see
conversion diagram e).
2
positioning (13) two revolutions. Move
the forearm support to the lower
recess in the slot and turn it 180° in
this position. Then move the forearm
support back to the middle position
(setting 0) and tighten locking screw
(13) again (see conversion diagram
b, c).
1
f).
3
3