Querying Current Alarms - ORi X-zone Com Manual De Instrucciones

Operating Manual X-zone Com - Sending Text Messages to X-Zone Com

7.1.6 Querying current alarms

It is possible to request a list of current alarms. The list may contain gas or device error alarms. A gas
alarm transmits the following information: type of gas causing the alarm, current readings and unit of
measure, as well as the X-zone 5x00 where the alarm occurred. In the event of a device error, the sys-
tem communicates which X-zone 5x00 is experiencing the error, but does not provide an error code.
The information contained in the text message answer depends on your settings in the Manager Soft-
ware.
Fig. 7.9: Specifying the information in the Manager Software you require in the text message reply to your que-
ries.
[PIN] Alarm
In the event of a gas alarm (A1, A2)
Text Message Reply Contents
X-zone Com device name
Character sequence
Alarm type
Gas type
Concentration (optional)
Unit of measurement (optional)
X-zone 5x00 ID (optional)
In the event of a X-zone 5x00 device error
Text Message Reply Contents
X-zone Com device name
Character sequence
Alarm type
X-zone 5x00 ID (optional)
Value Ranges
User-specified ASCII character sequence
User-specified ASCII character sequence
A1, A2
Abbreviated gas name of X-am 5x00
0 to 10,000
Vol%, %UEG, %LEL, %LIE, ppm, mg/m3,
ppb, mbar, hPa, kPa, mg/L
0 to 15 or X-zone 5x00 serial number
Value Ranges
User-specified ASCII character sequence
User-specified ASCII character sequence
"Device alarm"
0 to 15 or X-zone 5x00 serial number
51