Connection Information; Connecting To X-Zone Com; Automatic Search - ORi X-zone Com Manual De Instrucciones

Configuration:
3
3
Select device, log, and communication settings. In addition, shows various types of in-
formation, such as device ID, device status, and battery status.
Measuring values:
4
4
In an open network, displays current readings of locally connected X-zone 5x00. In the
event of an alarm, the alarm data of the device issuing the alarm also appear.
In a closed network, displays current maximum and alert values from the group.
Status bar
5
5
Shows the status of the connection to X-zone Com.
Also allows the language selection of Manager software and shows the Manager Soft-
ware version.
5.3

CONNECTION INFORMATION

5.3.1 Connecting to X-zone Com

PCs and X-zone Com connect via a RS232 connection cable or Bluetooth. When you use a RS232
cable, usually, the system assigns COM Port 1.
The Manager Software can search for the COM Port for the serial Bluetooth connection automatically,
or you can assign the COM Port manually.

Automatic search

5.3.1.1
If the software has been installed, its default setting is automatic search and it will search for a COM
Port. Make sure [AutoDetect] is checked, as shown in Fehler! Verweisquelle konnte nicht gefunden
werden..
Click [Connect] to start the connection process. The status bar will show "Searching device
at:" and will also indicate at which COM Port the system is searching for a device.
Fig. 5.4: Software status bar seen when the system has successfully completed the connection.
28
NOTE
To connect using Bluetooth, enable the PC's Bluetooth module.
The operating system will also have to assign a virtual ComPort
to the device. Further information can be found in Chapter 5.1.
Rev20141022-01 / from FW 1.00z / SW 1.0.16