Measurements Section - ORi X-zone Com Manual De Instrucciones

Fig. 5.21: There are two errors.
5.5

MEASUREMENTS SECTION

Displays the current readings and alarms
Fig. 5.22: Readings and alarms in the Manager Software's Measurements Section. Group device 0 triggered both
alarms.
The table shows the identification number for the group's X-zone 5x00 for each device from which
readings were taken. It also displays the type of gas, current gas concentration and its unit of
measurement, as well as alarm type, if in fact, an alarm was triggered.
Above the table, you'll find information stating whether the connected X-zone 5x00 belongs to a open
or closed network (group) and if the reading is a local value or a maximum value of a group (see Ch.
4.2.4).
Heading
Current, LOCAL sensor readings (no
closed groups configured)
Current MAXIMUM sensor readings
(the connected device is not a master)
Current MAXIMUM sensor readings
Not connected to X-zone 5x00
40
Meaning
Open network: Displays sensor readings of the local X-zone 5x00
that is connected to X-zone Com.
Group: Maximum current readings taken from all the different
gasses in the network
Group: Maximum current measured value taken from all the
different gasses in the network
Not communicating with X-zone
Rev20141022-01 / from FW 1.00z / SW 1.0.16