Tabla de contenido
Mechanical installation
NEW: Necessary tools and instructions
See the applicable drive hardware manual.
NEW: Unpacking and examining the delivery
1. Open the option package.
2. Make sure that the package contains:
•
EtherCAT adapter module, type FECA-01
•
this manual.
3. Make sure that there are no signs of damage.
CHANGED: Installing the adapter module
WARNING! Obey the safety instructions. See chapter
you ignore the safety instructions, injury or death can occur.
The adapter module has a specific position in the drive. Plastic pins, a lock and one screw to
hold the adapter module in place. The screw also makes an electrical connection between the
module and drive frame for cable shield termination.
When the adapter module is installed, it makes the signal and power connection to the drive
through a 20-pin connector.
When you install or remove the adapter module from the control unit:
1. Pull out the lock.
1
2. Put the adapter module carefully into its position on the drive.
3. Push in the lock.
4. Tighten the screw to torque 0.8 N·m.
Update notice
Safety instructions
on page 11. If
Capítulos
Tabla de contenido
