Idiomas disponibles
Idiomas disponibles
Once a week
Once a month
If necessary
Central lubrication
Assembly / exchange saw blade
HOLZMANN Maschinen GmbH
Guide track and roller guide of
sliding table and rip fence
Moving parts
Central lubrication
Maintenance room
Saw blade, scoring saw blade
V-belt
Lubricants are toxic and must not be released into the environment!
Always follow the manufacturer's instructions and, if necessary, contact
your local authority for information on proper disposal.
Fill in the machine oil with a viscosity of ISO 32 (recommended
for ISO VG 32, DIN 51524/2 HLP, DIN 51517-3 CLP) via the filler
opening (1).
Max. oil volume: 0,6 l
Oil level must always be between min and max.
Pull the lever (2) to activate thel lubrication
Adjust the cutting height to the maximum possible level.
•
•
Set the saw blade to 90°.
Push the sliding table all the way foreward.
•
Open the saw blade guard (7).
•
Fix the drive shaft with the supplied fixing pin (5).
•
Loosen the flange nut (4) with the saw blade wrench (6)
•
(left-hand thread!)
Remove flange nut (4), flange (3) and saw blade (2) from
•
the drive shaft.
Clean the drive shaft, shaft flange (1) and all parts
•
thoroughly from impurities
Replace the old saw blade with a new one.
•
Make sure that the new saw blade is undamaged and not
•
dirty.
Place the saw blade (2), flange (3) and flange nut (4) on the
•
drive shaft.
Fix the drive shaft with the supplied fixing pin (5).
•
•
Tighten the flange nut with the saw blade wrench (6)
(left-hand thread!)
NOTE:
Retighten the flangenut tightly to prevent the nut from
loosening during operation.
(tightening torque: 50Nm)
Close the saw blade guard.
•
•
Bring the sliding table back into position.
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Clean, blow out
Lubricate
Check oil level, pull the lever for 3-5 times
Vacuum chips
Clean the motor housing
Change
Change
N O TE
59
FKS400V32PRO_400V
