Rip fence
Adjustment outrigger table
HOLZMANN Maschinen GmbH
Determine position before first movement:
- Push key (1)
- Enter password (1111) in key (2)
- Measure the distance between the rip fence and the saw blade and
enter the value in key (3).
- Make a test cut and compare the workpiece and the value.
- If the two values are not the same, enter the value of the workpiece
length in key (3)
- Push key (4) to return to the previous page
www.holzmann-maschinen.at
- Push key (1)
- Enter desired cutting width in the keybord
AUTOMATIC ADJUSTMENT OF THE RIP FENCE:
- Push button (2) and the rip fence moves to the
entered position
- The automatic movement can be stopped with
button (3) before the input value is reached
NOTE:
At a value <157mm the rip fence must be
moved manually with the fields (4 and 5)
MANUAL ADJUSTMENT OF THE RIP FENCE:
With the fields (4 or 5), the selected cutting width on
the rip fence can be moved manually by holding it
down. The adjustment of the rip fence stops when
the set value is reached.
Longitudinal adjustment:
- Loosen clamping lever (1)
- Move the rip fence to the desired position
- Fix clamping lever
NOTE:
2 possible positions.
Position A: for straight cuts
Position B: for angle cuts
After losing the clamping lever (1), the outrigger
table (2) can be moved along the sliding table. After
reaching the desired position, tighten the clamping
lever again.
ASSEMBLY
53
FKS400V32PRO_400V