Idiomas disponibles
Idiomas disponibles
HOLZMANN Maschinen GmbH
-
-
-
-
-
-
-
-
-
-
-
NOTE:
-
Saw blade guard:
-
-
-
-
-
-
-
Table settings:
-
-
-
-
-
-
NOTE:
Position A: for straight cuts
Position B: for angle cuts
The position is monitored by a sensor so that the
correct rip fence position to the saw blade is
guaranteed even in the event of a changeover.
www.holzmann-maschinen.at
1.
Bracket saw blade guard and display
Mount the bracket saw blade guard and display (1)
on the machine as shown
To do this, first remove the screws and spacers (3)
from the retaining bolts
Place the bracket saw blade guard and display on
the retaining bolts and fix it with screws and
spacers (3)
Mount the bracket with display (2) on the upper
arm of the bracket
To do this, first remove the bolt and nut (4) from
the holder
Position the bracket as shown
Insert the bolt again and fix it with the nut (5)
Mount the bracket saw blade guard (6) on the
lower arm of the bracket
To do this, first remove the bolt and nut (4) from
the holder
Position the bracket as shown
Insert the bolt again and fix it with the nut (5)
When mounting, make sure that the control
cable with protective hose is not too taut
Make the plug connection of the control cable plug
(7) and tighten the lock nut
Set the lock (10) to the "Open" position.
Slide required saw blade guard (8) onto saw blade
guard holder (9)
Set lock (10) to "Lock" position
2.
Table extension
Remove the screws, spring washers and washers (1)
from the threads (2) in the worktable
Position the table extension (3) on the worktable as
shown
Fix screws, spring washers and washers
Check alignment and adjust table if necessary
Loosen the screws (1) slightly
Adjust and fix plane and horizontal alignment with
set screws (4)
Tighten the screws firmly.
3. Rip fence
Slide the rip fence (2) on the guidance of the
bracket (2)
Fix the rip fence with the clamping levers (3) on
desired position
Connect the plug.
2 possible positions.
ASSEMBLY
47
FKS400V32PRO_400V
