Part-Arming The System; Part Arm-I" Mode; Part Arm-Ii" Mode; Disarming The System ("Disarm" Mode) - Honeywell FRIEDLAND FGGK Serie Manual De Instrucciones

7.3

Part-arming the system

7.3.1

"Part Arm-I" mode

Remote control
1. Press the button once.
7.3.2

"Part Arm-II" mode

Remote control
1. Press the button twice.
7.4

Disarming the system ("Disarm" mode)

Remote control
1. Press the button once.
Note: If the control panel is linked to a Spectra lighting receiver and the Spectra lighting control is enabled, any alarm condition
(except fire alarms) will cause the linked lighting to be switched on for the set lamp-on time.
If the system is disarmed using the duress code, the system will disarm as normal. All email contacts in the online account will
receive an email alert. All mobile devices running the app will be alerted. The appropriate duress message will be sent.
7.5

Quick-setting function

The quick-setting function fully arms the system with a 10-second exit delay.
1. Press the button.
2. Enter the 4-digit PIN code (User).
3. Press the button.
Note: If you press the button during the exit-delay period of any arming mode, the remaining exit-delay period will be reset
to 5 seconds.
7.6

Home automation buttons (I/II/III)

The home automation buttons on the control panel are used to operate the "Programmes" setup from in the PC setup software.
Refer to the software manual.
Note: If you press a home automation button, wait for a few seconds before pressing another button. The programme may not
be activated if you press the buttons too quickly.
Control panel
1. Press the button once.
2. Enter the 4-digit PIN code (User).
3. Press the button.
Control panel
1. Press the button twice.
2. Enter the 4-digit PIN code (User).
3. Press the button.
Control panel
1. Press the button once.
2. Enter the 4-digit PIN code (User).
3. Press the button.
25