Idiomas disponibles
Idiomas disponibles
6.2.5
Communication device setup (COMMS)
The feature concerns the use of transceiver-type of devices only. Transceiver-type of devices are used to communicate with the
control panel in order to allow remote access, control and configuration.
Note: The supplied IP gateway, pre-linked to the control panel, is an example of a communication device.
PROGRAM MODE
5. COMMS
6.2.5.1
Model type (MODEL TYPE)
You can set the model type for the communication device.
6.2.5.2
Learning the transceiver (LEARNING ID)
The control panel can learn up to 12 communication devices.
Press and hold the learn button on the transceiver for 3 seconds.
Message
LEARNING OK
TIME OUT
ID DUPLICATE
6.2.5.3
Device status (DEVICE STATUS)
You can enable or disable operation of the communication device.
Note: The device status automatically changes to "ON" after a communication device is linked to the control panel.
6.2.5.4
Deleting the device (DEVICE REMOVE)
You can delete the settings of the communication device from the control panel.
6.2.6
Backup and Restore (BACKUP & RESTORE)
PROGRAM MODE
6.2.6.1
Backup (BACKUP)
You can save the current settings in the control panel for backup purposes.
6.2.6.2
Restore (RESTORE)
If required, you can restore the saved settings.
5-1 COMMS SETUP
INPUT (01-12)
C DEVICE NO.
Default settings
Item
MODEL TYPE
LEARNING ID
DEVICE STATUS
The ID code was learned by the control panel successfully.
If you do not press the learn button on the transceiver within 30 seconds, a time-
The same ID code was learned by the control panel beforehand.
6. BACKUP & RESTORE
Default settings
Item
BACKUP
RESTORE
:1 MODEL TYPE
:2 LEARNING ID
:3 DEVICE STATUS
:4 DEVICE REMOVE
Message
---
---
OFF
Meaning
out will occur.
6-1 BACKUP. DD/MM/YY.
6-2 RESTORE. DD/MM/YY.
Message
DD/MM/YY (today)
---
23
WAIT LEARNING...
SELECT ON>* / OFF>#
SELECT YES>*/ NO>#
SELECT YES>*/ NO>#
SELECT YES>*/ NO>#
Capítulos
Solución de problemas
