Overview; Using The Keypad; Entering The Programming Mode - Honeywell Domonial CMI800 Manual Del Usario

E
N
EKZ008500A
G
L
1 - GENERAL
I
S

1-1 Overview

H
The TCU keypad provides a way of programming a Domonial panel without requiring any additional tool. The present document presents the
procedure for the most common programming options.

1-2 Using the keypad

The engineer performs the programming of the panel by navigating through screens and keying in commands. A summary of all screens is
presented at the end of this document in Annex I.
While in programming mode:
the key cancels the current operation or input, or navigate to the parent menu.
•
the OK OK key validates the current operation or input
OK OK
•
the left and right arrows are used either :
•
to scroll up and down within menus
o
to move across the list of registered devices in the device information screen
o
to delete (left arrow) the last character into an input field
o
the numeric keys are used to enter digits or characters into input fields. To key in a character, press repeatedly the key carrying the
•
required character until it is presented. In menus, the numeric keys also access directly to menu entries 1-9.
2 – MAIN OPERATIONS

2-1 Entering the programming mode

Once the panel is mounted, with its battery and mains supply connected, it is possible to open a programming mode session with any TCU
keypad by :
holding down the panel tamper switch for 3 seconds,
•
releasing it,
•
pressing the TCU programming switch "P" within 30 seconds.
•
The TCU will, if necessary, download its programming configuration from the panel. The engineer then proceeds through the screens.
Screen
Language selection
Initial menu
Code prompt
Language selection
SELECT LANGUAGE
< ENGLISH >
QUIT( ) YES(OK)
1
Action
Scroll available languages with arrows, then validate with
OK. OK OK OK
Select option 1 1 1 1 - - - - PROGRAMMING PROGRAMMING PROGRAMMING PROGRAMMING
Type in sequentially the 6 digits of installer code. A
turning key is shown during the input.
Initial menu
1-PROGRAMMING
2-RESTORE DEFAULT
3-QUIT
2
Result
> Initial Menu in the selected language
> Code prompt screen
> Programming main menu
Code prompt
ENGINEER
-------
TYPE CODE
--------
4/64
Programming main menu
1-REGISTER
2-VIEW DEVICES
3-PARAMETERS
4-DATE & TIME