Personal Attack Facility; Zone Lockout; Device Tamper; Chime Facility - Honeywell FRIEDLAND FGGK Serie Manual De Instrucciones

7.7

Personal attack facility

The user can trigger an alarm at any time in the event of threat or danger by activating the personal attack facility.
Remote control
1. Press and hold the
The alarm will continue for the alarm duration when the system will automatically reset or until the system is disarmed.
7.8

Zone lockout

If, while the system is armed, a single zone triggers an alarm more than three times and zone lockout is enabled, the zone will
be locked out. The siren will ignore other alarm signals from the zone. An alarm will not be triggered. The zone lockout will be
cancelled when the siren is disarmed. If zone lockout is disabled, a single zone can initiate any number of alarms. Zone lockout
operates with alarm zones only. Zone lockout does not operate with fire zones.
7.9

Device tamper

The tamper zone operates on a 24-hour basis. Receipt of a tamper signal from any device will immediately trigger an alarm
irrespective of systems armed/disarmed status unless the system is in test mode or program mode.
If the battery cover of any device (except remote controls) is removed or if the siren or the control panel is removed from the
wall, an alarm will occur immediately even if the system is disarmed (unless the system is in test mode or program mode). The
alarm will sound until the set alarm time expires or the system is disarmed from the remote control or the remote keypad.
7.10

Chime facility

You can only operate the chime facility with the system in standby mode.
1. Press the button to enable the chime facility.
2. Press the button again to disable the chime facility.
Note: To operate the chime facility using a security detector, set the chime mode for the zone of the security detector to "ON".
7.11

Spectra lighting (manual/automatic switching)

1. Press the button to switch the linked Spectra lighting ON.
2. Press the button to switch the linked Spectra lighting OFF and back to automatic operation.
7.12

Keyboard beeps

1. Press the button to mute the keyboard beeps.
2. Press the button again to unmute the keyboard beeps.
7.13

Entry/exit delay beeps

If the entry/exit delay beeps are enabled, you can temporarily disable them during the active delay period only.
1. Press the button to mute the entry/exit delay beeps.
2. Press the button again to unmute the entry/exit delay beeps.
Note: When the next entry/exit delay period starts, the beeps will follow the main system setting as normal.
7.14

Event log

The event log indicator flashes every 5 seconds to indicate that a new event entered into the event log. Only alarm events will
cause the control panel to beep every 10 seconds. Other system events (e.g. low-battery condition) will not initiate the warning
beeps.

Take one of the following actions:
- Press the button to switch off the event log indicator.
- Press the button to read the event message in the event log.
Each event message is shown on two displays. The first display shows the event number and when the event occurred. The
second display shows the actual content of the event.
button for 3 seconds.
Control panel
1. Press and hold the personal attack button for 3 seconds.
26