Honeywell FRIEDLAND FGGK Serie Manual De Instrucciones página 10

1. Pull out the clip and push down the mounting bracket to
remove it from the control panel.
2. Use the mounting bracket as a template to mark the
position of the mounting holes on the wall.
3. Drill mounting holes (5 mm) into the wall according to
the marked positions.
4. Insert a supplied wall plug into each mounting hole.
5. Remove the battery cover.
6. Make sure that jumper link P1 is in the off position.
7. Make sure that jumper link P51 is in the off position.
Note:
If the tamper alarm of the control panel sounds continuously,
reset the alarm:
a) Press the button.
b) Enter the 4-digit PIN code (User).
c) Press the button.
8. Connect the connector of the NiMH battery (7.2V) to the
battery connection.
9. Install the battery cover.
10. Connect the white power adaptor (12V) to the power
adaptor connection. Route the cable along the cable
track.
11. Install the control panel to the wall bracket.
10