Learning The Remote Control (Learning Id); Personal Attack Button (Panic); Status (Status); Deleting The Remote Control (Del Data) - Honeywell FRIEDLAND FGGK Serie Manual De Instrucciones

6.2.1.4

Learning the remote control (LEARNING ID)

The control panel can learn up to 8 remote controls.
1. Press the button on the remote control. The control panel emits two short beeps. The display shows "NEW DEVICE".
Note: If the remote control has already been linked, the control panel will emit one long beep.
2. Press the button on the remote control within 15 seconds to confirm the ID code. The control panel emits three
short beeps. The display shows "DEVICE CONFIRMED" > "SAVING NEW DEVICE".
Note: If the confirmation signal is not received within 15 seconds, the control panel will emit one long beep and exit learn
mode.
Message
LEARNING OK
TIME OUT
ID DUPLICATE
6.2.1.5

Personal attack button (PANIC)

If you press the personal attack button (
6.2.1.6

Status (STATUS)

The remote control will control the control panel if the remote control is lost unexpectedly.
6.2.1.7

Deleting the remote control (DEL DATA)

You can delete the settings of the remote control from the control panel.
6.2.2

System setup (SYSTEM SETUP)

PROGRAM MODE 2. SYSTEM SETUP
Letters Digits
. @ / : - _ → ^
1
ABC/abc 2
DEF/def 3
GHI/ghi 4
JKL/jkl 5
MNO/mno 6
The ID code was learned by the control panel successfully.
If you do not press the buttons on the remote keypad within 60 seconds,
The same ID code was learned by the control panel beforehand.
) on the remote control, the control panel will generate an alarm.
2-1 ALARM TIME
2-2 INT. SIREN
2-3 EXT. SIREN
2-4 ERROR BEEP
2-5 RF JAMMING
DETECTION
2-6 ALARM RELAY
2-7 ZONE LOCK
2-8 PART ARM-I SETUP
2-9 PART ARM-II SETUP
Letters Digits
PQRS/pqrs
TUV/tuv
WXYZ/wxyz
# $ % * + < >
＜＞ = [ ] ←→ `
! ? - , ' ; ( ) & " | ￥
Meaning
a time-out will occur.
10 SEC / 30 SEC / 1 MINUTE
/ 3 MINUTES / 5 MINUTES /
10 MINUTES
SELECT ON>* / OFF>#
:3-1 WIREFREE SIREN :1-1 LINK PANEL TO SIREN
:1-2 SIREN WORKING
:3-2 NIGHT ALARM SELECT ON>* / OFF>#
10 SEC / 30 SEC / 1 MINUTE
/ 2 MINUTES / 4 MINUTES /
OFF
SELECT ON>* / OFF>#
PULSE 2 SEC / PULSE 30 SEC
/ PULSE 1 MINUTE / PULSE
3 MINUTES / PULSE 5
MINUTES / ON UNTIL
DISARM
SELECT ON>* / OFF>#
:9-1 EXIT DELAY SELECT ON>* / OFF>#
:9-2 ENTRY DELAY BEEP SELECT ON>* / OFF>#
:9-3 EXIT DELAY BEEP SELECT ON>* / OFF>#
:10-1 EXIT DELAY SELECT ON>* / OFF>#
:10-2 ENTRY DELAY BEEP SELECT ON>* / OFF>#
:10-3 EXIT DELAY BEEP SELECT ON>* / OFF>#
16
7
8
9
0
*
#
SENDING ID CODE. WAIT
15S.
SELECT ON>* / OFF>#