Yamaha 25B Manual Del Propietário página 164

q
w
e
r
t
y
000635
602053
EMU00976
Removing the Propeller
1) Straighten the cotter-pin 1 and pull it
out using a pair of pliers.
2) Remove the propeller nut 2, washer 3
and spacer 4.
3) Remove the propeller 5 and thrust
washer 6.
EMU00397
Installing the Propeller
cC
8 Be sure to install the thrust washer
before installing propeller, otherwise,
lower case and propeller boss may be
damaged.
8 Be sure to use a new cotter pin and
bend the ends over securely. Other-
wise, the propeller could come off dur-
ing operation and be lost.
1) Apply Yamaha Marine grease or Corro-
sion resistant grease to the propeller-
shaft.
2) Install the thrust washer and propeller on
the propeller-shaft.
3) Install the spacer and washer. Tighten
the propeller nut to the specified torque.
Tightening torque:
Refer to "SPECIFICATIONS" page 4-1.
4) Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
NOTE:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, then tighten the nut further
to align it with the hole.
4-20
GB