Air Polishing Using The Jetshield ™ Accessory - DENTSPLY Cavitron Instrucciones Para El Uso

Section 8: Techniques for Use con't
To adjust the flow of powder:
• Adjust the powder flow rate by positioning the control
at H(12 o'clock), M(9 o'clock), or L(6 o'clock).
• For heavy stain removal set the control on "H".
• For light stain removal set the control on "L".
• The control can be set at any position between "H" and "L".
• The view window at the center of the pointer lets you
observe the powder flow (small white circle of powder)
during operation. If no flow is seen, check for clogging
or add cleaning powder.
8.5 Air Polishing using the JetShield
Accessory
Aerosol reduction device for use with air polishing systems.
JetShield assembly and accessories – see Fig. 1. The disposable
™
JetShield assembly is designed for single use; all other
™
components are reusable and are compatible with standard
clinic equipment.
Figure 1
A. Ejector tube
F. Connector
E. Ejector tube clip
Precautions:
The JetShield itself is designed for single use only. Use of
™
chemical or heat sterilization will lead to poor performance
and malfunction of product.
The reusable components are wipe-disinfectable, using clean
cloths and appropriate non-immersion type disinfectant. Wipe
once with disinfectant to remove bioburden, then use fresh cloth
and more disinfectant to clean surface. Dry with clean paper
towel or air.
Step-by-Step Instructions:
1. Remove entire assembly from package.
2. Insert air polishing insert nozzle through JetShield
and seat shoulder flush on nozzle. See Figure 2.
3. Insert connector on JetShield
ejector tube.
4. Insert connector of ejector tube into operator saliva ejector.
•
ENGLISH 10
™
B. JetShield
™
assembly
C. Connector
D. Handpiece clip
cup
™
assembly into the flexible
™
Figure 2
1. Insert air polishing nozzle
2. Seat shoulder flush on nozzle
3. Incorrect positioning
5. Place ejector tube clip around ejector tube and handpiece
cable such that cables drape together for patient and clinician
comfort.
6. (Optional) Place handpiece clip along handpiece, close to
handpiece/cable connection, such that clip is holding the
JetShield evacuation tube in place along handpiece.
™
7. Verify that slurry exits from the JetShield
unit is activated. Adjust saliva ejector as necessary.
8. Proceed with routine air polishing, applying cup to tooth
so cup flares slightly. Pivot nozzle inside cup, adapting to
mesial and distal surfaces. Apply 2 seconds of spray for each
segment of tooth, releasing foot control each time. If spray
escapes, readjust cup to maintain flat contact with tooth sur-
face, adjusting angle by pivoting nozzle inside of handpiece.
After completion of each procedure, remove JetShield
and dispose of JetShield according to applicable regulations.
™
Wipe-disinfect all other components before next use.
Figure 3
when air polishing
™
assembly
™