BIOTRONIK Reocor S Manual Tecnico página 33

30
Fixed parameters
High rate protection
1 ... 180 ppm
181 ... 250 ppm
Pulse waveform
Lead impedance monitoring
Acoustic warning
Lead connection
Electrical data/battery
Battery
Polarity
Inverse-polarity protection None: Polarity is irrelevant
Power consumption
Service time with new bat-
b)
tery
End of service (EOS)
Remaining service time
b)
after ERI signal
Behavior during battery
exchange
a) Registered trademark of Duracell Inc., Bethel, CT 06801
b) When using the battery type MN 1604 Duracell
Ambient conditions
Temperature range for operation
Temperature range for storage
Relative humidity
Atmospheric pressure
Noise level
286 ms ± 10%
214 ms ± 10%
Asymmetric, biphasic
Above 2000 Ω ± 15%, at 5 V amplitude
Touch-proof 2-mm connector ports;
Redel port, 6-pin via Redel adapter
• Alkaline-manganese type: IEC 6LR61 / ANSI 1604A
• 9 V leak-proof
• E.g. MN1604 Duracell
Cathodic
Typically 1 mA (70 ppm, 5.0 V, 500 Ω )
• 600 h (-10%) at 20°C (± 2°C)
• At: 70 ppm, 5 V, mode VVI, 500 ohm
• Until: ERI signal (EOS warning)
Flashing "Low battery" LED
• 36 hours
• At: 70 ppm, 5 V, mode VVI, 500 ohm
• Device remains ready for use for at least 30 s when the battery
is removed.
• The set Mode is retained.
®
+10°C ... +40°C
0°C ... +50°C
30% ... 75%, non-condensing
700 hPa ... 1060 hPa
50 dB
286 ms = 210 ppm, does not apply
for Burst
214 ms = 280 ppm, does not apply
for Burst
® ®a)
Procell
®
, Procell