Corghi ET88 Manual De Uso página 87

1. If the user does not wish to perform the spin with rim only, the first phase can be
skipped. To do this, after selecting the OPT program, activate the
Skip first OPT phase icon. Then fit the wheel complete with tyre on the balan-
cing machine and carry out the other phases (2, 3 and 4) as previously descri-
bed. The results obtained are less precise than those provided by the comple-
te procedure.
2. At the end of the second or third spin, the screen may show the OUT 1 and OUT
2 messages, respectively
In this case, it is advisable to exit from the program by selecting the
Exit icon.
The values of the weights necessary to balance the wheel will appear on the
screen.
This shortens the procedure, which means doing without a modest improvement
in the final results; however, it is possible to continue with the optimisation pro-
cedure.
3. At the end of the third spin, the screen may inform the user that the tyre should
be fitted on the rim the other way round. If the user does not wish to do this, or
if it is not possible, the
the machine will provide the instructions for completion of the program without
reversing the tyre.
The Enable tyre reversal icon reactivates the reversal function.
4. The user can exit from the optimisation procedure at any moment by simply
selecting the
5. If a different working environment is recalled between one phase of the OPT
procedure and the next, on return to the OPT environment performance of the
procedure restarts from the point where it was interrupted.
ET 88 operator's manual
Special cases
Disable tyre reversal icon should be selected;
Exit icon.
GB
87