Saving Or Cancelling Modifications; Advanced Programming; Setting A Device Channel; Declaring An X10 Receiver - Honeywell Domonial CMI800 Manual Del Usario

E
N
EKZ008500A
G
L

2-6 Saving or cancelling modifications

I
Screen
S
Programming main menu
H
Confirmation
or
Screen
Programming main menu
Confirmation
Note: after saving a configuration, if the panel LEDs turn on in a row and the panel siren plays beeps, this means one parameter was set with an
incorrect value. The installation cannot be completed until the value is corrected: please restart programming.
3– ADVANCED PROGRAMMING

3-1 Setting a device channel

There are three banks of 32 channels, corresponding to the three device families:
Detectors (channels D1 to D32). The transmission parameters, such as the call sequence or the transmitted alarm codes, are associated
•
with the detector channel. By reassigning a detector to a given channel it is possible to force the associated default transmission
profile.
Controllers (channels C1 to C32). There is no use today in modifying a controller channel.
•
Actuators (channels A1 to A32). Actuator channels are used to associate a given actuator with a keyfob, keypad or detector, as
•
described below in the "Configuring outputs" section.
The channel associated with each device can be viewed in the device information screen, and modified through the following procedure:
Screen
Programming main menu
View device
Edit device
Set channel

3-2 Declaring an X10 receiver

Screen
Programming main menu
Select address
Extra parameter
Extra parameter
Extra parameter
Result

3-3 Restoring default values

Screen
Initial menu
Confirmation
Action
Select option 8 8 8 8 - - - - ABORT ABORT ABORT ABORT
Validate with OK OK. All changes are lost. OK OK
Action
Select option 9 9 9 9 - - - - SAVE+QUIT SAVE+QUIT
SAVE+QUIT SAVE+QUIT
Validate with OK OK OK. All changes are saved. OK
Action
Select option 2 2 2 2 - - - - VIEW DEVICES VIEW DEVICES
VIEW DEVICES VIEW DEVICES
Use the arrows keys to select among the registered or
predefined devices, then validate with OK
Select option 3 3 3 3 - - - - SET CHANNEL SET CHANNEL
SET CHANNEL SET CHANNEL
Use the arrow keys to select an available channel, then
validate with OK OK. OK OK
Action
Select option 3 3 3 3 - - - - PARAMETERS PARAMETERS PARAMETERS PARAMETERS
Enter code !! " !'%
Enter value '
Enter value
Enter value HHUU, where HH and UU are the house and
unit codes programmed onto the X10 receiver.
HH: 2-digit number for "house" letter (00 for A)
UU: "unit" number minus 1 (00 for 1, 0A for 11)
Validate with OK OK OK OK
The first line of result indicates 0 if the X10receiver is
properly registered, 1 if it was already registered, 2 if it
failed. 6 if it failed due to the limit of 32 peripherals.
Action
Select option 2 2 2 2 - - - - RESTORE DEFAULT RESTORE DEFAULT RESTORE DEFAULT RESTORE DEFAULT
Hold for 2 seconds and release the panel tamper switch,
then validate with OK OK
OK OK
Result
The panel prompts for confirmation
> Initial menu
Result
The panel prompts for confirmation
> Initial menu
Result
> View device screen
> Edit device screen
OK. OK OK
> Set channel screen
> View device screen
Result
> Select address screen
> Extra parameter screen
> Extra parameter screen
> Extra parameter screen
> Result screen.
>Programming main menu
The newly created receiver now appears with type
A25 in the View device screen.
Result
> Confirmation screen
The panel will reset and restore to its default
parameters. In this situation it is necessary to re-
enter the programming mode.
6/64