Idiomas disponibles
Idiomas disponibles
Safety, Installation and Operations Manual - Original instructions
4. Unscrew the plug on the bottom of the oil chamber.
EN
6. Place the vessel containing the oil on a horizontal surface and let it stand for a few minutes to allow any water in it to settle to the bottom:
•
Oil clean and free from water: the mechanical seal is in good condition and new oil can be placed in the system.
•
Oil with a very little water: this may be due to bedding-in of the mechanical seal during the initial operating hours, creating a negligible amount
of water.
•
Oil containing water and dirt; the mechanical seal must be inspected and replaced with a new one. The replacement must be made by an
authorised Service Centre;
7. Screw the bottom plug onto the oil chamber.
Enclosure type
M08S - M08L
6.6 Fasteners
For replacement purpose, the fasteners shall be Class A2 70, A2 80, A4 70 or A4 80 according to ISO 3506-1.
Tightening torques (Nm)
M4
M5
M6
2.7
5.4
9.0
CAUTION
Use Loctite 243 threadlocker or equivalents
40
Enclosure type (WET)
CAUTION
8. Fill the mechanical seal chamber with
biodegradable lubricating oil
Mechanical seal chamber
oil capacity (ml)
2300
M8
M10
M12
M16
22
44
76
187
5. Allow the oil to drain into a vessel of suitable size, transparent if
possible.
NOTE: to check that the vessel is of sufficient capacity, refer to the
Table for the amount of oil in the chamber.
M08S - M08L
Use Loctite 243 threadlocker or equivalents
9. Screw the top plug onto the oil chamber.
M20
M24
M30
364
629
1240
Oil chamber plug
2x 3/8" DIN 906
better together
