Idiomas disponibles
Idiomas disponibles
12 Replaceable charging contact insert
4.2.5
Acoustical signals and indications on the display – hand piece
Function /
Hand piece Button operation
Error Condition
"SOFT-START"
• Press the " TIME / PROGRAM "
PROGRAM: 20 seconds
and
.
• Press the " STAND-BY" button
POLIMERISATION
• Press the " TIME / PROGRAM "
PROGRAMS:
– 20 seconds
– 10 seconds
• Press the " STAND-BY " button
– 5 seconds.
INTERRUPTION OF THE
• The exposure cycle can be interrupted at
EXPOSURE CYCLE
BATTERY-LOW SIGNAL
The residual charge
level of the battery is
sufficient for a few
exposure cycles.
DEFECTIVE
BATTERY SIGNAL
LED Light source
defective
OVERHEATING
CONDITION
BUILD-IN Tempera-
ture overload sensor
defective
Charging circuit of the
hand piece defective
Note: This condition is
detected only with hand
piece placed inside the
charging unit.
button
to select the
"SOFT-START" PROGRAM .
briefly to start the exposure.
button
to select the exposure
time on the display: 20 s – 10 s – 5 s.
briefly to start the exposure.
any time and program in use by pressing
the " STAND-BY " button
Acoustic signal/s emitted
• 1 beep when pressing the
" STAND-BY " button.
• 1 beep after 10 seconds of
exposure time.
• 1 beep at the end of
exposure time.
• 1 beep when pressing the
" STAND-BY " button.
• 1 beep a fter 10 seconds of
exposure time (only 20 s Mode).
• 1 beep at the end of
exposure time.
• 1 beep when pressing the
" STAND-BY " button.
.
• 2 beeps at the end of the expo-
sure cycle.
Only with hand piece placed into the
charging unit.
• 1 beep every second for
a period of 30 seconds.
No acoustical signal emitted.
• 3 beeps , the light
emission is stopped.
• 4 beeps at the start of
an exposure cycle.
• 1 beep per second for the length
of 30 seconds.
Display
indication
A round
spot
appears
side the ex-
GB
posure time
selected.
- 11 -
blinking
blinking
steady
blinking
blinking
