Kulzer Translux 2Wave Instrucciones De Uso página 65

PROBLEM
The four round spots of the display
are blinking when the hand piece is
placed into
the charging
unit.
blinking
blinking
POSSIBLE CAUSE
Charging circuit inside the hand piece
defective.
The built-in temperature overload sensor
is defective.
REMEDY
Contact Kulzer and/or authorized Kulzer
service partners only.
Contact Kulzer and/or authorized Kulzer
service partners only.
Note: If the temperature overload sensor
fault occurs during an exposure cycle,
the software allows completing the
exposure. No further exposure cycle is
allowed by pressing the " STAND-BY "
button and " 4 beeps " are emitted.
GB
- 25 -