Precautions During Spo 2 /Pulse Monitoring; Monitoring Procedure - Gima CMS8000 Manual Del Uso

Note
Do not perform SpO
2
blood flow during NIBP measuring may adversely affect the reading of SpO

12.2 Precautions during Spo 2 /Pulse Monitoring

Note
• Make sure the nail covers the light window;
• The wire should be on the backside of the hand.
• SpO value is always displayed at the same position.
2
• SpO waveform is not proportional to the pulse volume.
2
• Please read the measured value when the waveform on screen is equably and steady-going,
This measured value is optimal value. And the waveform at the moment is the standard one.
• Pulse Rate will be displayed only under following situations:
- Select HR FROM as "SpO
- Select HR FROM as "AUTO" in the ECG SETUP menu and there is no ECG signal.
Warning
• Check if the sensor cable is in normal condition before monitoring. After unplugging the SpO
from the socket, the system shall display the error message "SpO
alarm.
• When operating at the beginning, the operator inserts his finger, and setup the SpO
the current measured value, then the machine will start alarm. The pulse rate alarm test is the same with
the above.
• Do not use the SpO
to the vendor.
• Prolonged and continuous monitoring may increase jeopardy of unexpected change of dermal condition
such as abnormal sensitivity, rubescence, vesicle, repressive putrescence, and so on. It is especially
important to check the sensor placement of neonate and patient of poor perfusion or immature dermogram
by light collimation and proper attaching strictly according to changes of the skin. Check per 2~3 hours the
sensor placement and move it when the skin deteriorates. More frequent examinations may be required for
different patients.

12.3 Monitoring Procedure

SpO 2 plethysmogram measurement
1. Switch on the monitor.
2. Attach the sensor to the appropriate site of the patient finger.
3. Plug the connector of the sensor extension cable into the SpO
Figure 12-1 Mounting of the Sensor
• Neonate SpO 2 Measurement
The process of measuring neonate SpO
of neonate SpO sensor and its installation.
2
1. Neonate SpO sensor
2
Neonate SpO sensor consists of Y-form SpO
2
Y-form SpO sensor respectively into the upper and lower grooves on the sheath (figure 12-2). Figure 12-3
2
shows us the neonate SpO
measuring and NIBP measuring on same arm at one time, because obstruction of
" or "BOTH" in the ECG SETUP menu.
2
sensor once the package or the sensor is found damaged. Instead, you shall return it
2
is similar to that of measuring adult SpO
2
sensor after insertion.
2
socket on the SpO
2
sensor and its sheath. Insert the LED and PD ends of the
2
value.
2
SENSOR OFF" and give the audible
2
ALM HI lower than
2
module.
2
. Below is the description
2
66
sensor cable 2