Maintenance And Cleaning; What Is Spo 2 Monitoring - Gima CMS8000 Manual Del Uso

65
Prompt message (general alerts):
Message Cause
RR EXCEED RR measuring value exceeds the measure range.

11.10 Maintenance and Cleaning

11.10.1 Care and Cleaning
Warning
Before cleaning the monitor or the sensor, make sure that the equipment is switched off and disconnected
from the power line.
If there is any sign that the ECG cable may be damaged or deteriorated, replace it with a new one instead of
continuing its application on the patient.
• Cleaning:
Use fine-hair cloth moistened in mild soap liquid or cleaning agent containing 70% ethanol to clean the
equipment.
• Disinfection
To avoid long-term damage to the device, we suggest to disinfect the device only necessary during the
maintenance plan. And we suggest to clean the device first before disinfection.
Advised disinfection material:
1. Ethanol group: 70% alcohol, 70% isopropanol
2. Aldehyde group
Chapter 12
SPo 2 MonItorInG

12.1 What is Spo 2 Monitoring

SpO Plethysmogram measurement is employed to determine the oxygen saturation of hemoglobin in the
2
arterial blood. If, for example, 97% hemoglobin molecules in the red blood cells of the arterial blood combine
with oxygen, then the blood has a SpO
read 97%. The SpO
2
oxygen molecules to form oxyhemoglobin. The SpO
and a plethysmogram wave.
How the SpO 2 / PLETH Parameter Works
• Arterial oxygen saturation is measured by a method called pulse oximeter. It is a continuous, non-invasive
method based on the different absorption spectra of reduced hemoglobin and oxyhemoglobin.
It measures how much light, sent from light sources on one side of the sensor, is transmitted through
patient tissue (such as a finger or an ear), to a receiver on the other side.
• The sensor measurement wavelengths are nominally 660nm for the Red LED and 880nm for Infrared LED.
Maximum optical power output for the Red LED is 6.65 mW and the Infrared LED is 6.75 mW.
• The amount of light transmitted depends on many factors, most of which are constant. However, one of
these factors, the blood flow in the arteries, varies with time, because it is pulsating. By measuring the light
absorption during a pulsation, it is possible to derive the oxygen saturation of the arterial blood. Detecting
the pulsation gives a PLETH waveform and pulse rate signal.
• The SpO value and the PLETH waveform can be displayed on the main screen.
2
• SpO is a non-invasive measurement of the functional oxygen saturation.
2
Warning
• Pulse oximeter can overestimate the SpO
cals.
• ES (Electrosurgery) equipment wire and SpO
• Do not put the sensor on extremities with arterial catheter or venous syringe.
SpO 2 / Pulse Monitoring
oxygen saturation of 97%. The SpO
2
numeric shows the percentage of hemoglobin molecules which have combined with
/PLETH parameter can also provide a pulse rate signal
2
value in the presence of Hb-CO, Met-Hb or dye dilution chemi-
2
cable must not be tangled up.
2
Alarm Level
HIGH
numeric on the monitor will
2