Gima CMS8000 Manual Del Uso página 187

67
Figure 12-2 Neonate SpO 2 Sensor (1)
Figure 12-3 Neonate SpO 2 Sensor (2)
2. Attaching Neonate SpO
Wind the SpO sensor around a hand or foot. Hold the sensor, pull the belt and fit one of its sides with "V"
2
edge into the "V" groove on the corresponding side of the sheath. Appropriately elongate the belt (about
20mm) and fit the "V" edge of the other side of the belt into the "V" groove of the other side of the sheath
and then loosen the belt. After the "V" edges of the two sides of the belt fit well into the "V" grooves on the
two sides of the sheath, put the belt into the first lock bar to fasten the belt. See figure 12-4. If the belt is too
much long, you may put it into the second lock bar. You must position the SpO
make the photoelectric component face the correct position. In the mean time, note not to elongate the belt
too much, which may lead to inaccurate measurement and also blocking the blood circulation severely.
Figure 12-4
Note
• If the sensor cannot be positioned accurately to the part to be measured, it may result in inaccurate SpO
reading, or even that the SpO
position the sensor again.
• The excessive patient movement may result in inaccurate reading. In this situation, you must keep the
patient quiet or change the part for monitoring to reduce the adverse influence of excessive movement.
Warning
• In the process of extended and continuous monitoring, you should check the peripheral circulation and the
skin every 2 hours. If any unfavorable changes take place, you should change the measured position in
time.
• In the process of extended and continuous monitoring, you should periodically check the position of the
sensor. In case that the position of the sensor moves during monitoring, the measurement accuracy may
be affected.
sensor
2
cannot be measured because no pulse is detected. If this is true, you must
2
sensor in this way so as to
2
2