Gima CMS8000 Manual Del Uso página 139

19
5.VIEWBED SCREEN
This monitor can view one parameter waveform and measured data from another patient monitor (viewbed
monitor) on the same monitoring network. To enter the following screen, open FACE SELECT menu, select
VIEWBED SCREEN, and then select EXIT.
Figure 3-12 ViewBed Screen
The monitor you are viewing from is called "host monitor". The monitor being viewed is called "viewbed
monitor". The viewbed screen is always displayed at the lower part of the host monitor's waveform area.
It consists of the following parts.
1. Viewbed monitor label
The viewbed monitor lable allows you to select the viewbed monitor you want to view. It displays the bed
number of the viewbed monitor. If the host monitor is not connected with any other monitor on the same
network, the label displays N/A.
2. Viewbed parameter area
All parameter data of the viewbed monitor is displayed in this area.
3. Viewbed waveform label
The viewbed waveform label allows you to select a waveform of the viewbed monitor. If the viewbed
monitor does not dispaly any waveform, this label displays N/A.
4. Viewbed waveform area
The viewbed waveform area is located beneath the viewbed waveform label. It displays the waveform
selected through the viewbed waveform label. Information relating to the viewbed waveform is shown above
the waveform.
3.4.2 Wave Setup
Select the [WAVE SETUP] item in the
"SYSTEM SETUP" menu to call up
the following menu:
Figure 3-13 Wave Setup
You can change the waveforms position.