Diamond C4GFEV7-BF Manual De Uso E Instalación página 37

B-C-D).
Do not operate any device which
•
could produce sparks or flames
(Detail B-C-D).
Use a means of communication
•
that is external to the environment
where there is a smell of gas to
warn the relevant entities (electrici-
ty operator and/or fire-fighters).
NEW! REMOVABLE BOTTOM / VD.
SECT. ILL - REF. q)
Before proceeding with the ope-
rations, see "General safety infor-
mation".
OBLIGATIONS - PROHIBITIONS -
ADVICE
Upon receipt, open the machine
packaging and ensure that the
machine and accessories have
not been damaged during transporta-
tion. Where this is found to be the case,
notify the carrier immediately and do
not proceed with installation but contact
the qualified and authorised personnel.
The manufacturer is not liable for dam-
age caused during transportation.
HANDLING SAFETY /
Failure to follow the instructions re-
ported below could result in expo-
sure to the risk of serious injury.
The operator authorised for the
handling and installation opera-
tions of the appliance must pre-
pare, if necessary, a "safety plan" in or-
der to ensure the safety of the persons
involved in the operations. In addition,
they must follow and strictly and scrupu-
lously implement the laws and regula-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
POSITIONING AND HANDLING
- 8 -
In the models provided (free cupboard
bottom), it is possible to remove the
lower surface for installation and main-
tenance operations (eg inspections,
connections, cleaning etc). To remo-
ve the bottom, unscrew and remove it
(Part A). To reposition the bottom, in-
sert and screw again (Part B).
In case of doors, need to disas-
sembled before (hinges and
fixing).
tions relating to mobile sites.
Ensure that the lifting means
adopted have capacity that is
adequate for the loads to be lifted and
are in a good state of maintenance.
Perform the handling operations
using lifting means with a capa-
city appropriate to the weight of
the appliance increased by 20%.
Follow the directions on the
packaging and/or on the same
appliance before handling.
Check the centre of gravity of the
load before lifting the appliance.
Lift the appliance to a minimum
height from the ground in order to
ensure its handling.
Do not stand or pass under the ap-
pliance during lifting and handling.
HANDLING - TRANSPORTATION /
- see SECT. IMAGES - REF. b).
The orientation of the packed
appliance must be maintained
according to the instructions
3.