Idiomas disponibles
Idiomas disponibles
Every technical change has an
effect on the operation or safety
of the appliance and must the-
refore be performed by technical per-
sonnel of the manufacturer or by tech-
nicians who are formally authorised by
the same. Failure to do so exempts
the manufacturer from any liability for
for any possible resulting modifica-
tions or damage.
Upon arrival, check the integrity
of the appliance and its compo-
nents (e.g. power cord), prior to
use. In the presence of faults do not
start the appliance and contact the ne-
arest service centre.
Read the instructions before
acting.
be performed. As far as personal pro-
tective equipment is concerned, the
European Community has issued Di-
rectives which the operators must com-
ply with. Noise ≤ 70 dB.
It is forbidden the installation of
stand alone equipment WI-
THOUT anti-tip kit (ACCES-
SORY). TOP versions excluded.
Before making the connections
check the technical data shown
on the rating plate of the applian-
ce and the technical data in this manual.
It is strictly forbidden to tamper with or
remove the plates and pictograms ap-
plied to the equipment.
Disconnect all supplies (water
- gas - electrical) upstream the
appliance whenever you need
to work in safe conditions.
Connect the appliance when pre-
sent, in the sequence of the water,
then to the gas network. Ensure
there are no leaks then proceed with the
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
Wear
protective
equipment suitable
for the operations to
- 5 -
connections to the mains.
The appliance is not designed to
work in an explosive atmosphe-
re and as such its installation
and use is categorically prohibited in
such environments.
Position the entire structure, re-
specting the installation dimen-
sions and characteristics indica-
ted in the specific chapters of this
manual.
The appliance is not intended for
recessed installation. / The ap-
pliance must be used in a well
ventilated area. / The appliance must
have free drainage (not hindered or im-
peded by foreign bodies).
The gas equipment must be in-
stalled beneath an extraction
hood whose system must have
specifications in compliance with the
current regulations in the country of use.
Once the appliance is connect-
ed to the power and drain
sources, it must remain static
(fixed) in the place of use and mainte-
nance.
Incorrect
cause danger.
Use where appropriate flexible
cable for connection to the mains
electricity supply with characteri-
stics not inferior to model H07RN-F.
The supply voltage supported by the
cable with the appliance working must
not differ from the nominal voltage va-
lue ± 15% shown at the bottom of the
technical data table.
The appliance must be included
in an "Equipotential" ground dis-
charge system.
Drainage of the appliance must
be conveyed into the grey water
discharge network in an open
connection
may
2.
EN
