GGP ITALY A 38x Manual De Instrucciones página 35

14
EN
Chain maintenance table
WARNING!
are shown in the "EC Conformity Statement" provided. Do not use other types of chains or bars
for safety reasons.
The table gives the sharpening data for different types of chains, but this does not mean you
can use different chains from the homologated one.
Chain pitch
inches
3/8 Mini
0.325
3/8
0.404
BAR MAINTENANCE (Fig. 26)
To avoid asymmetrical wear on the bar, make
sure it is turned over periodically.
To keep the bar in perfect working order, pro-
ceed as follows:
– grease the bearings on the nose sprocket (if
present) with the syringe;
– clean the bar groove with the scraper;
– clean the lubrication holes;
– with a flat file, remove burr from the edges and
level off the guides.
Replace the bar whenever:
– the groove is not as deep as the height of the
drive links (which must never touch the bot-
tom);
– the inside of the guide is worn enough to
make the chain lean to one side.
EXTRAORDINARY MAINTENANCE
All maintenance operations not foreseen in this
manual must be performed exclusively by your
dealer.
All and any operations performed in unautho-
rised centres or by unqualified persons will total-
ly invalidate the warranty.
The specifications of the chain and the bar homologated for this machine
Limiter tooth level (a)
mm inches
9.32 0.018
8.25 0.026
9.32 0.026
10.26 0.031
MAINTENANCE AND STORAGE
a
mm
0.45
0.65
0.65
0.80
STORAGE
After every work stint, clean the machine thor-
oughly to remove all dust and debris, and repair
or replace any faulty parts.
The machine must be stored in a dry place away
from the elements and with the bar cover cor-
rectly fitted.
LONG PERIODS OF DISUSE
IMPORTANT
the machine for a period of more than 2-3
months, we recommend you do a few things
before putting it away. This will make it easier
when you want to use the machine again and will
also prevent permanent damage to the engine.
• Storage
Before putting the machine away:
– Empty the fuel tank.
– Start the engine and run it idle until it comes to
a halt, so that it uses up all the fuel that is left
in the carburettor.
– Wait for the engine to cool down and remove
the spark plug.
File diameter (d) d
inches mm
5/32 4.0
3/16 4.8
13/64 5.2
7/32 5.6
If you are not going to use