Tabla de contenido
EN
M
Mount the sliding tubes [4 in Fig. 5.10] over the rollers on
the slide plates on the HTL frame [5 in Fig. 5.10]. Push the
tubes forward until the end stops [1 in Fig. 5.7-5.9] hit the
rear face of the slide plate [5 in Fig.5.10].
If the sliding tubes would hit the mudguard of the vehicle,
the air bag, or any other parts of the vehicle prematurely,
the position of the end stops [1 in Fig. 5.7-5.9] in the slid-
ing tubes, or the length of the sliding tubes can be ad-
justed accordingly [See also Fig. 5.16].
Do not drill, weld, cut... any parts of the slide
tubes or the vehicle chassis, until the full
mounting position of the HTL has been vali-
dated and tested with positive result.
DHOLLANDIA
5.10
EJ.
5
37
4
Tabla de contenido
