Tabla de contenido
EN
M
5) MOUNTING OF THE HTL FRAME AND THE SLIDING
TUBES
§5.1 - Test fitting the HTL frame and the sliding tubes
Position the lift frame on a wheeled jack (order code
M0025) [See 1 on Fig. 5.1], or use a similar device to slide
the frame under the chassis of the vehicle [See Fig. 5.2].
Slide the frame under the chassis, and raise the lift arms
to the fitting jigs (or the articulation hands on the platform).
Slide the articulation pins through the fitting jigs (or plat-
form hands) and the articulations on the lift arm [See Fig.
5.3].
If it is difficult to raise the lift arms, or to present the frame
in the correct fitting position [See below & Fig. 5.4], dis-
connect the forks of the cylinders from the lift arms [See 2
in Fig. 5.1].
Raise it to the fitting height C [See chapter 3].
While doing this, don't force either side (left or right) of the
frame higher or lower than the position it is taking natu-
rally, without exercising any special force.
In side view, make sure that the top face of the HTL frame
is perfectly parallel with the body and the chassis [See
Fig. 5.4].
If applicable (not for SM80, SMP... with integrated slide
plates), fit the slide plates over the frame, and mount the
front brackets, washers and M24 nuts loosely. Do not
tighten the nuts at this stage [See Fig. 5.5].
DHOLLANDIA
5.1
2
5.3
!
5.4
31
5.2
1
5.5
Tabla de contenido
