Lampe Temoin Phare De Route (F. 35); Luz Indicadora Deslumbrante (F. 35) - Malaguti F18 WARRIOR Manual De Instrucciones

F18 - 125
F18 - 125
cc / 150cc
cc / 150cc
F18 - 125cc / 150cc
F18 - 125
F18 - 125
cc / 150cc
cc / 150cc
DRIVING BEAM PILOT LIGHT (F. 35)
DRIVING BEAM PILOT LIGHT (F. 35)
DRIVING BEAM PILOT LIGHT (F. 35)
DRIVING BEAM PILOT LIGHT (F. 35)
DRIVING BEAM PILOT LIGHT (F. 35)
white/black
white/black
- Tester terminal (+): white/black
white/black cable terminal
white/black
- Te s t e r t e r m i n a l ( - ) : b l a c k
b l a c k
b l a c k cable terminal
b l a c k
b l a c k
• Change-over switch key on "ON"
• Position the light change-over switch on (
• Position the left change-over switch on driving beam (
- Voltage must be 12 Volts.
12 Volts.
12 Volts.
12 Volts.
12 Volts.
- Out of specification: the circuit between the four-way connector, which is fitted into the dashboard, and the left
change-over switch connector is defective. Locate the break between white/black
- According to the specification: the circuit is efficient. Check the lamp holder and the dashboard printed circuit. If
necessary, replace.

LAMPE TEMOIN PHARE DE ROUTE (F. 35)

LAMPE TEMOIN PHARE DE ROUTE (F. 35)
LAMPE TEMOIN PHARE DE ROUTE (F. 35)
LAMPE TEMOIN PHARE DE ROUTE (F. 35)
LAMPE TEMOIN PHARE DE ROUTE (F. 35)
- Borne (+) testeur : cosse câble blanc/noir
- Borne (-) testeur : cosse câble n o i r
• Clef démarreur sur "ON"
• Mettre le commutateur feux sur (
• Mettre le commutateur gauche sur le phare de route (
- La tension doit être de 12 volts.
- Non conforme aux indications : le circuit entre le connecteur à quatre voies introduit dans le tableau de bord, et le
connecteur du commutateur gauche est défectueux. Trouver l'interruption entre câble blanc/noir
- Conforme aux indications : le circuit est en état de marche, contrôler la douille et la piste de circuit imprimé du
tableau de bord, si besoin est, changer.

LUZ INDICADORA DESLUMBRANTE (F. 35)

LUZ INDICADORA DESLUMBRANTE (F. 35)
LUZ INDICADORA DESLUMBRANTE (F. 35)
LUZ INDICADORA DESLUMBRANTE (F. 35)
LUZ INDICADORA DESLUMBRANTE (F. 35)
- Terminal (+) tester: terminal cable blanco/negro
- Terminal (-) tester: terminal cable negro
• Llave conmutador en "ON"
• Situar el conmutador luces en (
• Situar el conmutador izquierdo en deslumbrante (
- La tensión debe ser de 1 2 v o l t
- Fuera del valor especificado: el circuito entre el conector de cuatro vías conectado en el salpicadero, y el conector
del conmutador izquierdo es defectuoso. Individuar la interrupción entre cable blanco/negro
- Como el valor especificado: el circuito funciona, controlar el portalámpara y salpicadero, si es necesario sustituir.
)
blanc/noir
blanc/noir
blanc/noir
blanc/noir
n o i r
n o i r
n o i r
n o i r
)
12 volts.
12 volts.
12 volts.
12 volts.
blanco/negro
blanco/negro
blanco/negro
blanco/negro
negro
negro
negro
negro
)
1 2 v o l t
1 2 v o l t
1 2 v o l t
1 2 v o l t.
) :
white/black
white/black
white/black cable and repair.
white/black
) :
) :
51
11/00
blanc/noir
blanc/noir
blanc/noir e t r é p a r e r .
blanc/noir
blanco/negro
blanco/negro
blanco/negro y r e p a r a r . .
blanco/negro

Capítulos

loading