Idiomas disponibles
Idiomas disponibles
lnstaBiationInstructWons (continued)
Step
9
Installing the Anti-Tip Device
WARNING:
• Range
must be secured
with an approved
Anti-
Tip device,,
• Unless
properly
installed,
the
range
could
be
tipped
by you or a child standing,
sitting or lean-
ing on an open door,,
. After installing
the Anti-Tip
device,
verify that it is
in place
by carefully
attempting
to tilt the range
forward,.
• This range has been designed
to meet all recog-
nized industry tip standards
for all normal condi-
tions.,
° The use of this device does not preclude
tipping
of the range when not properly
installed,
o If the Anti-Tip
device
supplied
with the
range
does
not fit this application,
use the universal
Anti-Tip
device WB02X7909
1. Mark the wall where the RIGHT EDGE of the range
is to be located, Be sure to allow for the countertop
overhang
if you intend to install the range next to
cabinets°
Anti-Tip
I
Device
I
Stotted
12:_
_ _¢H J-.__
I
screw
_
.{
1 11
W alip]ata I
,_
2W
"I'" Marked edge of range
(&4 cm)/_
2. Locate the outside edge of the device 2W' (5,4 cm)
toward the center of the range from the marked edge
of the range,
3. Using the device as a template,
mark the position of
the hole for the screw
4. For wood construction,
drill a pilot hole at an angle of
20 degrees from the horizontal,
A nail or awl may be
used if a drill is not available.
Mount the Anti-Tip device with the screw provided,,
For cement
or concrete
construction,
you will need a
1/4" x 1½" lag bolt and a I/2"
O,D
sleeve
anchor,
which are not provided,
Drill the recommended
size
hole for the hardware,.
Install the sleeve anchor
into the drilled hole and then
install
the
lag bolt through
the
device°
The
bolts
must be properly
tightened
as recommended
for the
hardware,,
Wallboard
Anti-Tip
Device
Back of range
Wood screw
5. Slide
the range
against
the wall,
and check
for
proper
installation
by grasping
the front edges
of
the
rear
surface
unit
openings
and
carefully
attempting
to tiIt the range forward,
WHEN ALL HOOKUPS ARE COMPLETED:
MAKE
SURE
ALL
OF THE
CONTROLS
ARE
LEFT IN THE OFF POSITION.
MAKE
SURE
THE
FLOW
OF
COMBUSTION
AND
VENTILATION
AIR
TO THE
RANGE
IS
UNOBSTRUCTED.
4O
