Bosch EPS 205 Manual Original página 9

Read all the safety information before using
the EPS 205. Always keep the operating in-
structions in a safe place.
3. Important safety information
3.1 Mains voltages
Hazardous voltages can occur in both power
networks and electrical systems. There is a
risk of electric shock from contact with live
components or from flashover resulting from
damaged insulation.
Safety measures:
¶
Only connect the EPS 205 to a properly grounded
connection.
¶
Do not allow the three-phase AC connecting cable
to hang over the edge of the workbench and do not
route it over hot pipes or running fans.
¶
Replace cables with damaged insulation.
¶
The EPS 205 is not to be operated if the three-phase
AC connecting cable is damaged or following failure
of or damage to the EPS 205 before the EPS 205 has
been checked by qualified Customer service person-
nel.
¶
If an extension cable is required for the three-phase
AC supply of the EPS 205, the cross-section of the
extension cable must be at least equal to that of the
connecting cable of the EPS 205. Extension cables
with an inadequate cross-section may be subject to
overheating. Route the extension cable such that
there is no risk of tripping over or pulling out the
three-phase AC connector.
¶
Always unplug the three-phase AC connector when
the EPS 205 is not in use. Never tug on the three-
phase AC connecting cable to unplug the three-
phase AC connector. Always grasp hold of the three-
phase AC connector and then unplug it.
¶
Inspect/check the electrical equipment every 2 years
in conjunction with the Testing department and
rectify any defects immediately.
¶
Only use fuses of the specified rating.
¶
Only perform assembly work with the EPS 205
switched off.
Robert Bosch GmbH
Important safety information | EPS 205 | 9
3.2 Danger of injury, danger of crushing
3.2.1 Transport, initial startup and shutting down
During transport or initial startup and shut-
ting down processes injuries and damage may
occur from dropped objects.
Safety measures:
¶
Wear safety shoes.
¶
Use protective equipment, e.g. gloves.
¶
Allow the EPS 205 to cool down before transporta-
tion.
¶
Wrap the three-phase AC connecting cable loosely
around the EPS 205 when putting the EPS 205 into
storage.
¶
Load and transport test equipment and test speci-
mens only in accordance with the Operating Instruc-
tions.
¶
Use suitable transport equipment and hoisting gear
with sufficient load-bearing capacity only.
¶
Transport and operate the equipment only in accor-
dance with the operating instructions.
3.2.2 Clamping, connecting and testing the test
sample
When clamping and connecting the test
equipment and test sample injuries may oc-
cur as a consequence of dropped objects and
sharp edges.
Safety measures:
¶
Wear safety shoes.
¶
Use protective equipment, e.g. gloves.
¶
Attach protective cover, e. g. protective hood for
drive coupling.
en
|
1 689 989 186 2017-10-27