Bosch EPS 205 Manual Original página 10

en 10 | EPS 205 | Important safety information
3.3 Danger of fire, danger of explosion
When working with test oil fire and explosion
are a risk.
Safety measures:
¶
Do not smoke.
¶
No naked flames or sparking sources.
¶
Use ISO 4113 test oil only.
¶
Do not use or mix materials such as diesel fuel,
gasoline etc.
¶
To reduce the risk of fire, never operate the EPS 205
in the vicinity of open containers or inflammable
liquids (e.g. gasoline).
3.4 Danger of burning
Danger of burning as a consequence of hot
parts, test oils and surfaces.
Safety measures:
¶
Use protective equipment, e.g. gloves.
¶
Caution must be exercised when handling hot oper-
ating and auxiliary materials (Danger of burning or
scalding).
3.5 Danger of slipping
Danger of slipping and falling through oil or
oil residue on the ground.
Safety measures:
¶
The connections used to supply test oil or lubricat-
ing oil to test accessories or the test specimen are
to be sealed before transporting.
¶
Rectify cause of leakage.
¶
Collect any escaped oil (e.g. test oil, lubricating
oil) immediately using liquid-binding material and
then disposed of in accordance with the applicable
regulations.
|
1 689 989 186 2017-10-27
3.6 Danger of detonation
Flammable vapors may be generated dur-
ing the testing process. Risk of detonation
through sparking or fire.
Safety measures:
¶
Do not smoke.
¶
No naked flames or sparking sources.
¶
The operator must ensure that the work area is
properly ventilated.
3.7 Danger of injury, danger of fire
The test oil jet which escapes at high pres-
sure and at high temperature may cause inju-
ries and burns.
Safety measures:
¶
Wear safety glasses.
¶
Do not reach into the escaping test jet.
¶
Tighten all hydraulic connections before initial startup.
¶
High-pressure hoses (operating pressure greater
than 60 bar) are to be replaced after 3 years (refer
to date of manufacture on high-pressure hose) even
if there are no apparent defects of relevance to
safety.
¶
Replace hydraulic hoses at the specified or at appro-
priate intervals (we recommend every 6 years).
¶
Check lines, hoses and screwed connections regu-
larly for leakages and externally visible damage.
Rectify all damage immediately.
¶
Route and mount all hydraulic and pressure lines
professionally! Do not mix up connections! The
fittings, length and quality of hose lines must meet
the specifications.
Robert Bosch GmbH