Important Notes On Operation Of Optional Equipment - Pfeifer 181520 Traducción Del Manual Original

7. Important notes on Operation of Optional Equipment

7.1 The lugs for suspension via chain slings each
have one hole for fitting a shackle. A 2-strand chain
sling can be hooked into the shackles. The permissible
tilt angle is max. 45°. Please refer to the following table
for a list of matching shackles:
Load capacity per
spreader beam kg
If the tilt angle exceeds 45° the lugs
may become deformed and/or the
welds may tear. This can cause the
spreader beam and/or load to fall.
DANGER
7.2 The additional lug in the centre can be exposed to
a maximum load that corresponds to the load capacity
of the spreader beam. Slinging gear can be hooked in
the lug via a matching shackle. Please refer to the
following table for a list of matching shackles:
Load capacity per
spreader beam kg
Overloading the centre lug may
cause deformation or falling of the
lug and/or the spreader beam or
toppling over of the load.
DANGER
PFEIFER spreader bars 01/2016 V 2.0 / Subject to technical changes!
8
Matching shackle
Pfeifer article no.
1000 181520
1600 181523
2500 181524
4000 181526
6300 181528
10 000 181531
16 000 181538
20 000 181538
Matching shackle
Pfeifer article no.
1000 181520
1600 181523
2500 181524
4000 181528
6300 181534
10 000 181534
16 000 181538
20 000 181540
7.3 The lateral mounting hooks for the adjustment
hoops are suitable for hooking slinging gear. The per-
missible tilt angle of the slinging fear is max. 45°.
If the tilt angle exceeds 45° the
hooks may become deformed and/
or the welds may tear. This can
cause the load and/or spreader
beam to fall.
DANGER
7.4 The welding hooks at the face are suitable for
hooking slinging gear. The permissible tilt angle of the
slinging gear is max. 45°.
If the tilt angle exceeds 45° the
hooks may become deformed and/
or the welds may tear. This can
cause the load and/or spreader
beam to fall.
DANGER
7.5 The screw-mounted resting bases can be attached
or removed as needed. Please observe the correct
tightening torque when screwing. Please refer to the
following table for a list of the required tightening tor-
ques:
Load capacity per Screw size
spreader beam kg
1000
1600
2500
4000
6300
10 000
16 000
20 000
The resting bases may tear off the
spreader beam if the screws are not
properly fastened. This can cause
the resting bases, spreader beam
and/or load to fall.
WARNING
Tightening
torque Nm
M10 45
M12 85
M12 85
M16 205
M16 205
M16 205
M16 205
M16 205