Troubleshooting Guide - Bostitch RC10SQ-M Manual De Instrucciones De Funcionamiento Y Seguridad

TROUBLESHOOTING GUIDE

© Bostitch
This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. The operator
or maintenance personnel can perform some corrective actions, and others may require the assistance of a qualified BOSTITCH
GB Not to be reproduced without permission. Unauthorised copies of this document do not constitute CE
technician or your dealer.
compliance for the products.
Problem
FR Reproduction interdite sans permission préalable. Les copies non autorisées de ce document ne
Excessive air tank pressure-safety valve pops off
signifient en rien que les produits soient conformes aux normes CE.
Air leaks
Air leaks in air tank or at air tank welds
DE Vervielfältigung nicht ohne Genehmigung gestattet. Unzulässig erstellte Kopien dieses Dokuments
Air leaks between head and valve plate
erfüllen nicht die CE-Richtlinien für Produkte.
Air leaks from safety valve
Knocking Noise
NL Mag niet worden vermenigvuldigd zonder toestemming. Onrechtmatige kopieën van dit document
willen niet zeggen dat de producten voldoen aan de CE-vereisten.
Pressure reading on the regulated pressure gauge drops when an accessory is used
Compressor is not supplying enough air to operate accessories
DK Må ikke gengives uden tilladelse. Uautoriserede kopier af dette dokument udgør ikke CE overholdelse
Regulator knob has continuous air leak
for produkterne.
Regulator will not shut off air outlet
FI Ei saa jäljentää ilman lupaa. Tämän asiakirjan ilman valtuutusta tehdyt kopiot eivät muodosta tuotteille
CE-yhdenmukaisuutta.
GR Απαγορεύεται η αναπαραγωγή χωρίς προηγούμενη άδεια. Τα μη εξουσιοδοτημένα
αντίγραφα του παρόντος εγγράφου δεν αποτελούν συμμόρφωση CE για τα προϊόντα.
CODE POSSIBLE CAUSE
IT Vietata la riproduzione senza permesso. Le copie non autorizzate di questo documento non
1
garantiscono la conformità CE per i relativi prodotti.
Pressure switch does not shut off motor
when compressor reaches cut-out pressure
NO Skal ikke reproduseres uten tillatelse. Ikke godkjente kopier av dette dokumentet oppfyller ikke
kravene for CE-merking for produktet.
2
Pressure switch cut-out too high
PT Reprodução proibida sem autorização prévia. As cópias não autorizadas deste documento não estão
em conformidade com a CE para os produtos. 3
Tube fittings are not tight enough
ES Prohibida la reproducción sin permiso. Las copias no autorizadas de este documento no suponen la
4
conformidad con las normas CE de los productos.
Defective air tank
SE Prohibida la reproducción sin permiso. Las copias no autorizadas de este documento no suponen la
conformidad con las normas CE de los productos.
5 Leaking seals
PL Niniejszy dokument nie może być kopiowany bez pozwolenia. Nieautoryzowane kopie niniejszego
dokumentu nie stanowią deklaracji zgodności CE prezentowanych produktów.
6 Defective safety valve
CZ Niniejszy dokument nie może być kopiowany bez pozwolenia. Nieautoryzowane kopie niniejszego
dokumentu nie stanowią deklaracji zgodności CE prezentowanych produktów.
SK Rozmnožovanie bez povolenia je zakázané. Neoprávnené kópie tohto dokumentu nie sú v súlade s CE
Regulator is not adjusted correctly for
7
pre dané výrobky.
accessory being used
HU A dokumentum engedély nélkül nem sokszorosítható. Az engedély nélkül sokszorosított dokumentum
nem jelenti a termék CE-megfelelőségét.
8 Prolonged excessive use of air
RO Reproducerea neautorizată este interzisă. Copiile neautorizate ale acestui document nu reprezintă
conformitatea CE pentru produse.
POSSIBLE SOLUTION
Set the On/Off switch to OFF (0), if the unit does not shut off
contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Tighten fittings where air can be heard escaping. Check fittings
with soapy water solution. Do Not Overtighten.
Air tank must be replaced. Do not repair the leak.
m WARNING: Risk of bursting. Do not drill into, weld or
otherwise modify air tank or it will weaken. The air tank can
rupture or explode.
Contact a BOSTITCH factory service center or a BOSTITCH
authorized service center.
Operate safety valve manually by pulling on ring. If valve still
leaks, it must be replaced.
It is normal for some pressure drop to occur when an accessory
is used, adjust the regulator as instructed in 'Adjusting Operating
Pressure' if pressure drop is excessive.
NOTE: Adjust the regulated pressure under flow conditions while
accessory is being used.
Decrease amount of air usage.
Code
1,2
3
4
5
6
6
7
8, 9, 10, 11, 12
13
11, 14, 15, 16, 17,
18, 19, 20
GB
11