Balancing Programmes; Dynamic Balancing (Standard) - Corghi EM 7240 Manual De Uso

Type of weight
Traditional clip
Adhesive
Adhesive
Adhesive
The positions on the wheel of H 3, H 6 and H 12 are shown in Figure 11c.

BALANCING PROGRAMMES

Before starting a balancing operation, the following steps must be followed:
- Fit the wheel on the hub using the most suitable flange;
- Lock the wheel so that no movement is possible during the wheel spin and braking
phases;
- Remove any counterweight, pebble, dirt or other foreign body;
- Set the wheel's geometric data correctly.
Proceed as follows to balance a wheel in dynamic mode:
- Press the
illuminates.
- Press the key
This programme is automatically launched when the machine is switched on.
- Set the wheel's geometric data.
- Spin the wheel by lowering the guard.
To obtain the most accurate results, do not apply any undue stress to the machine
EM 7240 Operator's manual
Weight application position
Always H 12
H 3
H6
H12

Dynamic balancing (standard)

and keys until the LED corresponding to the DYN programme
to confirm the selection.
11c
UK
79