Wheel Spin (Version Without Guard); Wheel Spin (Version With Guard); Balancing Programmes; Dynamic Balancing (Standard) - Corghi ProLine 650 Manual De Uso

by gram (or in tenths of an ounce if display
in ounces is active).
Pressing the key consecutively allows the
user to set one display mode or the other.
WHEEL SPIN
(VERSION
WITHOUT GUARD)
Press button
WARNING
During machine use, personnel may not
be present in the area enclosed by the
sectioning in Fig. 5a.
WARNING
If the wheel continues spinning without
stopping due to a machine malfunction,
switch the machine off from the main
switch or disconnect the plug from the
power board (emergency stop) and wait
until the wheel stops before lifting the
guard.
WHEEL SPIN
(VERSION WITH
GUARD)
Wheel spin takes place automatically when
the guard is lowered, or can be triggered
by pressing the START key with the guard
lowered.
A special safety device stops rotation if the
guard is raised during the spin; in this case,
the "A Cr" message is displayed.
WARNING
Do not operate the machine without the
User manual ProLine 650
on the screen.
guard and/or if the safety device has been
tampered with.
WARNING
Never raise the guard before the wheel
has come to a stop.
WARNING
If the wheel keeps spinning permanently
due to a fault on the machine, switch off
the machine using the main switch or dis-
connect the plug from the power supply
board (emergency stop) and wait until
the wheel stops before raising the guard.
bALANCING
PROGRAMMES
before starting a balancing operation, the
following steps must be followed:
- fit the wheel on the hub using the most
suitable flange;
- lock the wheel so that no movement is
possible during the wheel spin and brak-
ing phases;
- remove any counterweight, pebble, dirt
or other foreign body;
- set the wheel's geometric data correctly.

Dynamic balancing (standard)

Proceed as follows to balance a wheel in
dynamic mode:
- Press the
the LED corresponding to the DYN pro-
gramme illuminates.
- Press the key
selection.
This programme is automatically launched
when the machine is switched on.
- Set the wheel's geometric data.
UK
and keys until
to confirm the
59